AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Setup apple airport express on wind 104/14/2024 In general, Macs will usually do a nice job of switching between access points to pick up the best signal as they move about the house. It's always better to use products from the same manufacturer in a roaming network. Rarely are there any "best" settings to use on any network. Frankly, I pay no attention to what channels my 3 AirPorts are using.īasically, it boils down to personal preference. Some AirPorts might use the same channel and they might use different channels. My recommendation would be to use the "Automatic" setting for channels and let the AirPort scan and select the best channel to use. Channels 1, 6 and 11 tend to be the most crowded, though. This is fine as long as there are not multiple other networks around you using the same channels. If you assign different SSIDs to each AirPort, then you will have to log on to a different network when you move a WiFi device closer to another AirPort access point. If you want devices to "roam" and connect to the AirPort with the best signal, this is the only way to accomplish it. The recent change was to get another Apple AirPort Extreme (tower) and use that instead of Spectrum's Router.Īny pointers or suggestions are welcomed.ĭepends on your goals. If I turned off and turned back on WiFi (iPhone or iPad), it worked fine. I have had some challenges in the past when I had a Spectrum WiFi Router as the first device."roaming" between the areas of the house sometimes didn't appear to be switching to another access point and had marginal connectivity. Anything about the above that doesn't seem like the right approach?.Is my channel set up appropriate? I have seen different comments about using the same channels versus spreading things out.Is it best to use same SSID across all of these (with same security and password)?.I have also set each of these to be on a separate channel (1, 6, 11 on 2.4GHz and 36, 40, & 44 on 5GHz). They all have the same SSID defined with same security protocol and same password. The 2nd two AirPorts are set up as Router Mode=Off (Bridge Mode).Īll three are set up in the wireless section to: Create a wireless network. the other two AirPorts are connected via Ethernet at different locations in the house (essentially 1 in front of house, one in middle, and one in back). I currently have one of the AirPorts acting as a Router and is directly connected to Cable Modem. I now have 3 Apple AirPort Extremes and want to set up WiFi to be best coverage and seamless as I move around.
0 Comments
Read More
Leave a Reply. |